RFI (Request For Information)

RFI (Request For Information)

Thank you for contacting us. If you have an inquiry, the best is to fill in the questionnaire in the enclosure. For each measuring Point, we need one entry.

If you have questions about the form, we would be delighted to know!

In the meantime, here are some documents.

    • Related Articles

    • What to do when the USB stick was lost or fails?

      The USB sticks that we supply are industrial and they never failed. If you use your own USB stick, note that we did tests on them and they all failed the test. So make sure to create a copy of the content of ours before you use it. The recommendation ...

    • What is the maximum pressure of our sensor?

      The maximum pressure of our SSiC sensor (QP015-UDP-SIC-LT) is 80 bar. This is not officially tested, but tested during an indicative test. We could test it on higher pressures on request. For higher pressures, like 600 or 6000 bar, we can create a ...

    • Does Arenal offer HART protocol

      Yes, we offer HART protocol in our analyzer, however our analyzer offer much more information then can be transmitted over this protocol. The protocol does not suit process analysers, only small pressure and temperature transmitters. We suggest to ...

    • What is the torque value when mounting the lap joint SSiC sensor QP018?

      The SSiC lap joint flange is stronger than any material. When fixing it to the stainless steel flange, do not over-tighten the value of the bolts. The maximum bolt value for M6 is 11,7 Nm. We recommend to keep the torque value below this value, say ...

    • 7 Years warranty on the probe !

      New warranty from April 1, 2023: The QP015-UDP-SiC-LT probe is covered by a seven-year warranty. During this period, products that prove to be defective will, at the discretion of Arenal Mining & Dredging B.V., be either repaired or replaced, without ...