What is the torque value when mounting the lap joint SSiC sensor QP018?

What is the torque value when mounting the lap joint SSiC sensor QP018?

The SSiC lap joint flange is stronger than any material. When fixing it to the stainless steel flange, do not over-tighten the value of the bolts.
The maximum bolt value for M6 is 11,7 Nm.
We recommend to keep the torque value below this value, say 10 Nm or 7,3 lbf.ft
Note these instructions:
- there must be a new packing in between the SiC and the steel flange;
- the sensor must be concentrically mounted in the flange;
- there must be a steel ring between the bolt and the SiC;
- the steel flange must be flat;
- the bolts must be tightened crosswise;
- the bolts may not touch the SiC.

If you need more information, please let us know.

The Arenal Support team.



    • Related Articles

    • What is the maximum pressure of our sensor?

      The maximum pressure of our SSiC sensor (QP015-UDP-SIC-LT) is 80 bar. This is not officially tested, but tested during an indicative test. We could test it on higher pressures on request. For higher pressures, like 600 or 6000 bar, we can create a ...

    • What is the hardness of the sintered silicon carbide probe

      Our sensor QP015-UDP-SIC is made from sintered silicon carbide (SSiC). Arenal is the only company making ultrasonic sensors with this material. Is is designed to fit in mineral processing plants and dredging and rilling applications. It does not wear ...

    • What to do when the USB stick was lost or fails?

      The USB sticks that we supply are industrial and they never failed. If you use your own USB stick, note that we did tests on them and they all failed the test. So make sure to create a copy of the content of ours before you use it. The recommendation ...

    • 7 Years warranty on the probe !

      New warranty from April 1, 2023: The QP015-UDP-SiC-LT probe is covered by a seven-year warranty. During this period, products that prove to be defective will, at the discretion of Arenal Mining & Dredging B.V., be either repaired or replaced, without ...

    • RFI (Request For Information)

      Thank you for contacting us. If you have an inquiry, the best is to fill in the questionnaire in the enclosure. For each measuring Point, we need one entry. ...