Date and time Settings

How to set Date & Time in the C7X ?

To set the date and time in the C7X display, follow next steps:

The date and time can be seen on the Configuration Menu / User Settings

...and on the data logging page (picture was taken on an other date and time).

The logger will use this date and time to store the measured and calculated values. It is not convenient to match a wrong date&time in a database with samples from the client. So, change the date&time according to the local settings.
From April 2024, you will be able to do this from the front-end, so from the pages above. But the firmware up to 4.1.0 does not allow this yet.
It needs to be changed from the back end, so from the Cimon menu. Log in with the Service account. 
In any screen, press the Ethernet icon on the bottom bar (2nd from left).
The following menu appears:


Press Exit.

Press Settings

On the left bar, press System Time.

Set the correct date and time. Go back with the arrow on the top left.
Then press Canvas Viewer.

    • Related Articles

    • What to do when the USB stick was lost or fails?

      The USB sticks that we supply are industrial and they never failed. If you use your own USB stick, note that we did tests on them and they all failed the test. So make sure to create a copy of the content of ours before you use it. The recommendation ...

    • How to connect the QA03 analyzer to your PC

      Connect your analyzer system to your PC by connecting the PC with a normal UTP cable to the HMI. Or, on the base board undo the switch PoW and connect the UTP cable in the RJ45 connector. Or, connect to the VPN router (cost apply). Once connected use ...

    • RFI (Request For Information)

      Thank you for contacting us. If you have an inquiry, the best is to fill in the questionnaire in the enclosure. For each measuring Point, we need one entry. ...

    • 7 Years warranty on the probe !

      New warranty from April 1, 2023: The QP015-UDP-SiC-LT probe is covered by a seven-year warranty. During this period, products that prove to be defective will, at the discretion of Arenal Mining & Dredging B.V., be either repaired or replaced, without ...

    • Pressure influence on measurement

      We measure acoustic impedance, Z=c*d Pressure will increase the density of water and the speed of sound. The speed of sound is SQRT(K/density), while K is also pressure depending. Water is not very compressible especially with 50% solids. I think in ...