What is the hardness of the sintered silicon carbide probe
Our sensor QP015-UDP-SIC is made from sintered silicon carbide (SSiC). Arenal is the only company making ultrasonic sensors with this material.
Is is designed to fit in mineral processing plants and dredging and rilling applications.
It does not wear off.
The Vickers HV 0.5 (according to DINV
ENV 843-4) is 2300 GPa
Related Articles
7 Years warranty on the probe !
New warranty from April 1, 2023: The QP015-UDP-SiC-LT probe is covered by a seven-year warranty. During this period, products that prove to be defective will, at the discretion of Arenal Mining & Dredging B.V., be either repaired or replaced, without ...
What is the best place to mount the density sensor and the thermal massflow meter?
Hello, The point of installation is very important for a succesful measurement. In the datasheet you find all information about it. The minimum velocity for the density sensor of the flow shall be at least 1 feet or 30 cm. If you expect a lower ...
What to do when the USB stick was lost or fails?
The USB sticks that we supply are industrial and they never failed. If you use your own USB stick, note that we did tests on them and they all failed the test. So make sure to create a copy of the content of ours before you use it. We have three ...
Pressure influence on measurement
We measure acoustic impedance, Z=c*d Pressure will increase the density of water and the speed of sound. The speed of sound is SQRT(K/density), while K is also pressure depending. Water is not very compressible especially with 50% solids. I think in ...
How to get support from Arenal Support Team?
Hello, Welcome to the Arenal Service & Support Team in The Netherlands. We are trying to support you the best we can. We are working on a full automatic response system for small questions. When this is implemented (possibly end of February) we ...